Hello,
I trying set mac address on the interface
<code>
Firewall/admin(config)# interface gigabitEthernet0/2
Firewall/admin(config-if)# ?
Interface configuration commands:
asr-group Configure Asymmetrical Routing group id
default Set a command to its defaults
description Interface specific description
exit Exit from interface configuration mode
help Interactive help for interface subcommands
ip Configure ip addresses.
ipv6 IPv6 interface subcommands
management-only Dedicate an interface to management. Block thru traffic
nameif Assign name to interface
no Negate a command or set its defaults
security-level Specify the security level of this interface after this
keyword, Eg: 0, 100 etc. The relative security level between
two interfaces determines the way the Adaptive Security
Algorithm is applied. A lower security_level interface is
outside relative to a higher level interface and equivalent
interfaces are outside to each other
shutdown Shutdown the selected interface
</code>
I found how to set mac address with command mac-address but I don't have it in there.
http://www.cisco.com/c/en/us/td/docs/security/asa/asa72/configuration/guide/conf_gd/intparam.html
Thank you for any hint how to solve it.
