cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


367
Views
0
Helpful
0
Replies
Highlighted
Cisco Employee

ASA5525 (9.8(2) ) SNMP poll not responding

I  have been configured the ASA as SNMP agent, also allow poll traffic as follows but the firewall not responding to the request.

 

interface GigabitEthernet0/0
management-only
nameif out
security-level 100
ip address x.x.x.x/24 standby x.x.x.xx// Normal (Monitored)

 

snmp-server host out y.y.y.y poll community *****
snmp-server host out y.y.y.y poll community *****
snmp-server host out y.y.y.y community *****
snmp-server host out y.y.y.y community *****
snmp-server hostout y.y.y.y poll community *****
snmp-server host out y.y.y.y poll community *****
snmp-server host out y.y.y.y poll community *****
snmp-server location ......
snmp-server contact .........
snmp-server community *****
snmp-server enable traps syslog
snmp-server enable traps ipsec start stop
snmp-server enable traps entity config-change fru-insert fru-remove fan-failure power-supply power-supply-presence cpu-temperature chassis-temperature power-supply-temperature chassis-fan-failure
snmp-server enable traps memory-threshold
snmp-server enable traps interface-threshold
snmp-server enable traps connection-limit-reached
snmp-server enable traps cpu threshold rising
snmp-server enable traps ikev2 start stop
snmp-server enable traps nat packet-discard
snmp-server enable traps config

 

%ASA-6-302015: Built outbound UDP connection 653036 for out: y.y.y.y/162 (y.y.y.y/162) to identity:x.x.x.x/162 (x.x.x.x/162)

 

  33: 11:20:15.109964       802.1Q vlan#35 P0 y.y.y.y.53562 > 1x.x.x.x.161:  udp 109

  34: 11:20:17.606703       802.1Q vlan#35 P0 y.y.y.y.53562 > x.x.x.x.161:  udp 109