07-27-2011 10:20 AM - edited 03-11-2019 02:04 PM
I am having a problem configuring my ASA 5505 for NAT.
Based on my research the following config should work.
What am I missing.
Chris
07-27-2011 10:56 AM
Hi Chris,
The configuration looks good to me. Could you atke logs and captures, enable the following command:
access-list cap permit ip any host 4.2.2.2
access-list cap permit ip host 4.2.2.2 any
cap capin access-list cap interface inside
cap capo access-list cap interface outside
and to enable logs;
logging enable
logging buffered 7
and then initiate a ping from any inside machine and take the captures and logs.
show cap capin
show cap capo
show logging
these outputs would isolate the issue a lot.
and also if you are replacing the firewall, i would suggest you reload the ISP router and ASA once after saving the configuration.
Thanks,
Varun
07-27-2011 11:03 AM
Thanks for the reply.
I found the problem, I had mis-configured the workstation.
Chris
07-27-2011 11:05 AM
Ohhh ok...thats good
-Varun
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide