cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


1360
Views
0
Helpful
2
Replies
Highlighted
Beginner

Cisco 515E 169.154.x.x ip addresses only ? please help

Hello,

I have recently bought a Cisco pix 515E firewall primarily to learn from. I have had watchguard firewalls in the past.

Powers up ok, link lights up etc... but PC set to DHCP aquires only 169.154.x.x addresses ??

Cannot connect, cannot run reset command.

Is there a way to reset the device ? I have read the manuals and reset password seems to be an option but I dont

know the version of software running ...

please can someone help me just to get started ...

many thanks

Simon

Everyone's tags (6)
1 ACCEPTED SOLUTION

Accepted Solutions
Beginner

Cisco 515E 169.154.x.x ip addresses only ? please help

That IP means you did not recieve a DHCP address.   Console into the PIX and see if you can get into enable mode, then you can set that up.

View solution in original post

2 REPLIES 2
Advisor

Cisco 515E 169.154.x.x ip addresses only ? please help

Hi,

they should have given you a paper with the FOS version installed and so you should do a password reset provided there is already one, by default password is null. Try to connect with console cable and you'll see if you need to do a password reset otherwise then post the show run here.

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
Beginner

Cisco 515E 169.154.x.x ip addresses only ? please help

That IP means you did not recieve a DHCP address.   Console into the PIX and see if you can get into enable mode, then you can set that up.

View solution in original post

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here