08-12-2019 12:51 AM - edited 08-12-2019 03:18 AM
Hello,
I have a Cisco ASA 5510 with firmware 8.2(5)57.
I am going to change our ISP provider but in the meantime I want to have both active. Is there any way to have two ISP providers actives at the same time?
08-12-2019 05:44 AM
Yes, this is possible, you can connect each ISP router to a different interface on the firewall and then use SLA to monitor the routes in the event of a failure.
This guide here is a good place to start and I think it still applies to 8.2
Otherwise have a look at the SLA section of the 8.2 config guide here:
Hopefully this is helpful.
08-12-2019 09:39 AM
yes you can active / Active for both the ISP, but you can mix the load
take example :
instead of send 192.168.1.X to ISP 1 and 192.168.2.X to ISP 2, if ISP 1 fails
192.168.1.X to ISP2 and 192.168.2.X to ISP 2 already - same thing if ISP 2 fails.
i believe this reasonable approach for best usage with IP SLA tracking..
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: