07-18-2018 12:18 AM - edited 02-21-2020 07:59 AM
hi,
it's my first time to do active/active code upgrade on a 5525-X pair (no FP module). i usually upgrade an active-standby FW pair.
could someone advise their personal experience? is it the same upgrade procedure on a active-standby FW pair?
any commands to take note of especially on failover groups?
ciscoasa/pri/act# show run failover
failover
failover lan unit primary
failover lan interface FAIL-LAN GigabitEthernet0/7
failover link FAIL-LINK GigabitEthernet0/6
failover interface ip FAIL-LAN 192.168.254.53 255.255.255.252 standby 192.168.254.54
failover interface ip FAIL-LINK 192.168.254.73 255.255.255.252 standby 192.168.254.74
failover group 1
preempt 100
replication http
failover group 2
secondary
preempt 100
replication http
Solved! Go to Solution.
07-26-2018 07:04 AM
John-
The process is documented here:
HTH-
Vince
07-26-2018 07:04 AM
John-
The process is documented here:
HTH-
Vince
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: