02-11-2014 06:07 AM - edited 03-11-2019 08:44 PM
Hi All,
I have an ASA pair which runs in active/standy configuration and below is my problem:
- The standby ASA reloads every 7days once but at different times not the same time.
- Have replaced the ASA twice.
- Have changed the power point and rack as well.
- There is no crash info file on the flash.
Details of the asa is as below:
Show version:
sh ver
Cisco Adaptive Security Appliance Software Version 8.0(3)
Device Manager Version 6.4(5)106
Compiled on Tue 06-Nov-07 22:59 by builders
System image file is "disk0:/asa803-k8.bin"
Config file at boot was "startup-config"
XXXXX up 1 day 15 hours
failover cluster up 96 days 13 hours
Hardware: ASA5520, 2048 MB RAM, CPU Pentium 4 Celeron 2000 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash M50FW080 @ 0xffe00000, 1024KB
Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)
Boot microcode : CN1000-MC-BOOT-2.00
SSL/IKE microcode: CNLite-MC-SSLm-PLUS-2.01
IPSec microcode : CNlite-MC-IPSECm-MAIN-2.04
0: Ext: GigabitEthernet0/0 : address is 001d.4524.b166, irq 9
1: Ext: GigabitEthernet0/1 : address is 001d.4524.b167, irq 9
2: Ext: GigabitEthernet0/2 : address is 001d.4524.b168, irq 9
3: Ext: GigabitEthernet0/3 : address is 001d.4524.b169, irq 9
4: Ext: Management0/0 : address is 001d.4524.b165, irq 11
5: Int: Not used : irq 11
6: Int: Not used : irq 5
Licensed features for this platform:
Maximum Physical Interfaces : Unlimited
Maximum VLANs : 150
Inside Hosts : Unlimited
Failover : Active/Active
VPN-DES : Enabled
VPN-3DES-AES : Enabled
Security Contexts : 2
GTP/GPRS : Disabled
VPN Peers : 750
WebVPN Peers : 2
AnyConnect for Mobile : Disabled
AnyConnect for Linksys phone : Disabled
Advanced Endpoint Assessment : Disabled
This platform has an ASA 5520 VPN Plus license
I am not sure what else I should be looking into and this has been an ongoing issue. Please do shed some light and share you experience on this.
Thanks and Regards,
Kanes.R
02-11-2014 06:58 AM
Hi,
This may be bug (standby reload) with IOS the device currently running. Check Cisco bug toolkit for any known bugs.
Thx
MS
02-11-2014 07:30 AM
Hi Kaneswaran,
Could you provide with the syslog from standby ASA of the time when reload occurs?
- Prateek Verma
02-24-2014 04:44 PM
Hi Guys,
I will have the logs posted soon. Sorry for the delay in response.
Thanks and Regards,
Kanes.R
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: