06-29-2016 02:24 AM - edited 03-12-2019 12:57 AM
Hi Guys,
if you have two outside interfaces, can you monitor them using snmp?
They are setup as failover so if primary fails then secondary takes over.
At the moment primary responds to snmp polls but secondary interface does not . I cannot see any replies back from it . I can see traffic does reach it and it replies but that is about it .
please advice.
thanks
06-29-2016 03:47 AM
Hi,
Are you facing an issue with polling when secondary interface becomes the active member ?
Poll response will only be done by the interface which is on the active box.
Thanks,
Ankita
06-29-2016 03:51 AM
so if you have outside 1 and outside 2 and outside 1 is active
then outside 2 will not respond to polling ?
06-29-2016 06:50 AM
Have you enabled SNMP on the outside2 interface?
eg you will have:
snmp-server host outside1 X.X.X.X poll community your_community
Do you have the same sitting off of outside2?
06-29-2016 07:21 AM
yes I have
06-29-2016 05:46 PM
Hi,
Could you take captures on the outside2 interface for
Regards,
Aditya
Please rate helpful posts and mark correct answers.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide