Apologies but I'm new to cisco and command configurations and to be honest I'm at my wits end.
I have been set an assignment to configure the following to an existing network.
My education establishment uses version 7.2.1 although I'm not sure if this is relevant to my question.
I have to configure a GRE tunnel between two networks,
Add an OSPF, Add a VPN tunnel,
Add a Firewall between a router and Firewall switch, and create a zone-based firewall between the two.
The instructions to complete this are questionable and I have literally spent days trying to configure the commands without success.
My progress is monitored on the simulator and I have managed to achieve 78% but can't get any higher and to be honest, I have lost confidence in the instructions.
Would anyone be kind enough to give me the commands for the above so I have a fresh start, please?
I don't need the basic config stuff that's already done just the security additions.
Thanks from a very stressed student. SB.