Configuration mismatch on Standby ASA

kaneswaran_39 · ‎12-25-2012

act# sh console-output

Message #1 : Message #2 :

Total SSMs found: 1

Message #4 :

Total NICs found: 7

Message #5 : mcwa Message #6 : i82557 Ethernet at irq 11Message #7 : MAC: 442b.035d.3857

Message #8 : mcwa Message #9 : i82557 Ethernet at irq 5Message #10 : MAC: 0000.0001.0001

Message #11 : i82547GI rev00 Gigabit Ethernet @ irq11 dev 1 index 05Message #12 : MAC: 0000.0001.0002

Message #13 : i82546GB rev03 Gigabit Ethernet @ irq09 dev 2 index 03Message #14 : MAC: 442b.035d.385b

Message #15 : i82546GB rev03 Gigabit Ethernet @ irq09 dev 2 index 02Message #16 : MAC: 442b.035d.385a

Message #17 : i82546GB rev03 Gigabit Ethernet @ irq09 dev 3 index 01Message #18 : MAC: 442b.035d.3859

Message #19 : i82546GB rev03 Gigabit Ethernet @ irq09 dev 3 index 00Message #20 : MAC: 442b.035d.3858

Message #21 : Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)

Message #22 : Boot microcode : CN1000-MC-BOOT-2.00

Message #23 : SSL/IKE microcode : CNLite-MC-SSLm-PLUS-2.03

Message #24 : IPSec microcode : CNlite-MC-IPSECm-MAIN-2.06

Message #25 : Verify the activation-key, it might take a while...

Message #26 : Running Permanent Message #27 : Activation Key: Message #28 : 0x3300ed5b Message #29 : 0xf05b56ff Message #30 : 0x6812a904 Message #31 : 0xb0a004fc Message #32 : 0xce012e91 Message #33 :

Message #34 :

Licensed Message #35 : features for this platform:

Message #36 : Maximum Physical Interfaces : Unlimited perpetual

Message #37 : Maximum VLANs : 200 perpetual

Message #38 : Inside Hosts : Unlimited perpetual

Message #39 : Failover : Active/Active perpetual

Message #40 : VPN-DES : Enabled perpetual

Message #41 : VPN-3DES-AES : Enabled perpetual

Message #42 : Security Contexts : 2 perpetual

Message #43 : GTP/GPRS : Disabled perpetual

Message #44 : AnyConnect Premium Peers : 2 perpetual

Message #45 : AnyConnect Essentials : Disabled perpetual

Message #46 : Other VPN Peers : 5000 perpetual

Message #47 : Total VPN Peers : 5000 perpetual

Message #48 : Shared License : Disabled perpetual

Message #49 : AnyConnect for Mobile : Disabled perpetual

Message #50 : AnyConnect for Cisco VPN Phone : Disabled perpetual

Message #51 : Advanced Endpoint Assessment : Disabled perpetual

Message #52 : UC Phone Proxy Sessions : 2 perpetual

Message #53 : Total UC Proxy Sessions : 2 perpetual

Message #54 : Botnet Traffic Filter : Disabled perpetual

Message #55 : Intercompany Media Engine : Disabled perpetual

Message #56 :

This platform has an ASA 5540 VPN Premium license.

Message #57 :

Message #58 :

Cisco Adaptive Security Appliance Software Version 8.4(3)

Message #59 :

Message #60 : ****************************** Warning *******************************

Message #61 : This product contains cryptographic features and is

Message #62 : subject to United States and local country laws

Message #63 : governing, import, export, transfer, and use.

Message #64 : Delivery of Cisco cryptographic products does not

Message #65 : imply third-party authority to import, export,

Message #66 : distribute, or use encryption. Importers, exporters,

Message #67 : distributors and users are responsible for compliance

Message #68 : with U.S. and local country laws. By using this

Message #69 : product you agree to comply with applicable laws and

Message #70 : regulations. If you are unable to comply with U.S.

Message #71 : and local laws, return the enclosed items immediately.

Message #72 :

Message #73 : A summary of U.S. laws governing Cisco cryptographic

Message #74 : products may be found at:

Message #75 : http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

Message #76 :

Message #77 : If you require further assistance please contact us by

Message #78 : sending email to export@cisco.com.

Message #79 : ******************************* Warning *******************************

Message #80 :

Message #82 : Restricted Rights Legend

Message #83 : Use, duplication, or disclosure by the Government is

Message #84 : subject to restrictions as set forth in subparagraph

Message #85 : (c) of the Commercial Computer Software - Restricted

Message #86 : Rights clause at FAR sec. 52.227-19 and subparagraph

Message #87 : (c) (1) (ii) of the Rights in Technical Data and Computer

Message #88 : Software clause at DFARS sec. 252.227-7013.

Message #89 : Cisco Systems, Inc.

Message #90 : 170 West Tasman Drive

Message #91 : San Jose, California 95134-1706

Message #92 : .Message #93 :

act# sh failover history

==========================================================================

From State To State Reason

==========================================================================

09:44:53 EDT Jun 11 2012

Active Applying Config Active Config Applied Other unit wants me Active

09:44:53 EDT Jun 11 2012

Active Config Applied Active Other unit wants me Active

01:24:13 EDT Jul 14 2012

Active Failed Interface check

01:31:03 EDT Jul 14 2012

Failed Standby Ready Interface check

01:31:28 EDT Jul 14 2012

Standby Ready Failed Interface check

01:31:36 EDT Jul 14 2012

Failed Standby Ready Interface check

01:39:53 EDT Jul 14 2012

Standby Ready Failed Interface check

02:05:46 EDT Jul 14 2012

Failed Standby Ready Interface check

02:06:04 EDT Jul 14 2012

Standby Ready Just Active Other unit wants me Active

02:06:04 EDT Jul 14 2012

Just Active Active Drain Other unit wants me Active

02:06:04 EDT Jul 14 2012

Active Drain Active Applying Config Other unit wants me Active

02:06:04 EDT Jul 14 2012

Active Applying Config Active Config Applied Other unit wants me Active

02:06:04 EDT Jul 14 2012

Active Config Applied Active Other unit wants me Active

21:07:08 EST Nov 26 2012

Active Failed Interface check

21:07:11 EST Nov 26 2012

Failed Standby Ready Interface check

21:23:46 EST Nov 26 2012

Standby Ready Just Active Other unit wants me Active

21:23:46 EST Nov 26 2012

Just Active Active Drain Other unit wants me Active

21:23:46 EST Nov 26 2012

Active Drain Active Applying Config Other unit wants me Active

21:23:46 EST Nov 26 2012

Active Applying Config Active Config Applied Other unit wants me Active

21:23:46 EST Nov 26 2012

Active Config Applied Active Other unit wants me Active

============================================================

stby# sh console-output

Message #1 : Message #2 :

Total SSMs found: 1

Message #4 :

Total NICs found: 7

Message #5 : mcwa Message #6 : i82557 Ethernet at irq 11Message #7 : MAC: 442b.035d.3860

Message #8 : mcwa Message #9 : i82557 Ethernet at irq 5Message #10 : MAC: 0000.0001.0001

Message #11 : i82547GI rev00 Gigabit Ethernet @ irq11 dev 1 index 05Message #12 : MAC: 0000.0001.0002

Message #13 : i82546GB rev03 Gigabit Ethernet @ irq09 dev 2 index 03Message #14 : MAC: 442b.035d.385f

Message #15 : i82546GB rev03 Gigabit Ethernet @ irq09 dev 2 index 02Message #16 : MAC: 442b.035d.385e

Message #17 : i82546GB rev03 Gigabit Ethernet @ irq09 dev 3 index 01Message #18 : MAC: 442b.035d.385d

Message #19 : i82546GB rev03 Gigabit Ethernet @ irq09 dev 3 index 00Message #20 : MAC: 442b.035d.385c

Message #21 : Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)

Message #22 : Boot microcode : CN1000-MC-BOOT-2.00

Message #23 : SSL/IKE microcode : CNLite-MC-SSLm-PLUS-2.03

Message #24 : IPSec microcode : CNlite-MC-IPSECm-MAIN-2.06

Message #25 : Verify the activation-key, it might take a while...

Message #26 : Running Permanent Message #27 : Activation Key: Message #28 : 0x0b0be076 Message #29 : 0xb044740d Message #30 : 0xec83a5d0 Message #31 : 0x99c45cf4 Message #32 : 0xc02b2d97 Message #33 :