Configure multiple source hosts in NAT statement via CLI on ASA?

[CiscoPurpleBelt]

I have searched Cisco and online for docs showing the syntex for natting multiple hosts via command line. I can do it via ASDM, but want to know how to do it via CLI so the running-config does not show "DM_inline" making the configs look more complicated. Any help?

[Mohammed al Baqari]

This should help you

https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/115904-asa-config-dmz-00.html

**** remember to rate useful posts

[CiscoPurpleBelt]

Great thanks but I don't see anything about configuring multiple object hosts under a manual NAT config. So lets say I have object_singlehost_1 and object_single_host2 that I want to add as a source in a Manual Nat statement, just like in the attachment above. I am not sure how to configure it via command line. The below does not configure it like in the attachment:
nat (inside,outside) source static TEST_obj TEST2_obj destination static Outside_HP_Upstairs_WS Outside_HP_Upstairs_WS no-proxy-arp