cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


257
Views
0
Helpful
2
Replies
Beginner

EIGRP on ASA

I have an ASA 5520 on which I've enabled EIGRP. There are two routers to which it is a neighbor and these have equal cost distance to a network across the network. The network will automatically load-balance but the default is on a per destination basis. I would like to have it load balance on a per packet basis as we have one large load to the same destination. On the router IOS v12.4 there is a way to change this on a per interface basis (ip load-balance per-packet) but I haven't found the equivalent command in the ASA sw v 8.0(3). Does anyone know if there is such a command or another way to achieve this? Thanks.

2 REPLIES 2
Highlighted
Frequent Contributor

Re: EIGRP on ASA

Per-packet load balancing uses round-robin techniques to select the output path without basing the choice on the packet content.

http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/pplb.html#wp1038067

Beginner

Re: EIGRP on ASA

Yes, and it works great on a cisco router running v12. I'm trying to find the same command (or equivalent) on an ASA appliance running 8.0(3).