09-24-2019 06:57 AM - edited 02-21-2020 09:31 AM
Asa version 8.3.(1) .
Hi,
I am getting the error pool overlapping with the existing Pool. But I don't know why it is giving the warning
interface GigabitEthernet0/0
nameif Outside
security-level 0
ip address 1.1.1.2 255.255.255.248 standby 1.1.1.3
object network test
Host 10.0.2.10
object network o-nat
host 1.1.1.4
object network test
nat (inside,Outside) dynamic o-nat
It was just warning . But the real problem is internet is not working
If I give nat (Inside,outside) dynamic interface then the internet is working .
Here is 10.0.2.10 is not a host, in fact it is NATed IP of subnet 192.168.2.0/24 from another firewall .
I tried the below also
nat (inside,outside) source dynamic test o-nat ,but not worked
Please help
Thanks
09-24-2019 07:28 AM
You have only shared a small snippet of the configuration. We would need to see it all to determine where the conflict is coming from.
09-24-2019 07:55 AM
Hi,
I will share the full configuration after sanitizing,
Meanwhile, I will share another snippet.
The current nat configuration as below
object network test2
nat (inside,Internet) dynamic interface
object network test
nat (inside,Internet) dynamic interface
I am trying to change NAT for "object network test "
object network test
Host 10.0.2.10
object network o-nat
host 1.1.1.4
previous conf
object network test
nat (inside,outside) dynamic interface
after changing
object network test
nat (inside,Outside) dynamic o-nat
Thanks
09-24-2019 01:24 PM
Hi,
I can see there is dynamic and static nat for the same network ,
It could be an issue
nat (inside,Internet) source static admin admin destination static rusers rusers
!
object network admin
nat (inside, outside) dynamic interface
object network rusers
nat (any,Internet) dynamic interface
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide