I want to bundle two interfaces together. I configured Etherchannel on ASA. User the following procedure to configure it on VMware:
http://kb.vmware.com/selfservice/microsites/search.do?cmd=displayKC&externalId=1001938
My interface does not come up. Is this the only way to bundle two interfaces as one and directly connect it to a VMware server? Here is my show int and configuration:
Interface Port-channel47 "CAG-side", is down, line protocol is down
Hardware is EtherChannel/LACP, BW 1000 Mbps, DLY 10 usec
Auto-Duplex(Full-duplex), Auto-Speed(1000 Mbps)
Input flow control is unsupported, output flow control is off
MAC address e8b7.48fd.6c1a, MTU 1500
IP address 10.131.2.254, subnet mask 255.255.255.0
Members in this channel:
Inactive: Et0/0 Et0/1
Interface Port-channel47.101 "", is down, line protocol is down
Hardware is EtherChannel/LACP, BW 1000 Mbps, DLY 10 usec
VLAN identifier 101
Available but not configured via nameif
Interface Port-channel47.102 "", is down, line protocol is down
Hardware is EtherChannel/LACP, BW 1000 Mbps, DLY 10 usec
VLAN identifier 102
Available but not configured via nameif
interface Port-channel47
nameif ...
security-level 0
ip address 192.168.1.1 255.255.255.0
!
interface Port-channel47.101
vlan 101
no nameif
security-level 0
ip address 192.168.2.1 255.255.255.0
!
interface Port-channel47.102
vlan 102
no nameif
security-level 0
ip address 192.168.3.1 255.255.255.0
!
I checked the support page, and did not find any sample configurations. Can anyone provide a sample?
