Hello
I tried to update the firepower module of a cisco 5506 firewall but the installation of the module
it is failed, The final result is always Unresponsive
ciscoasa(config)# show module
Mod Card Type Model Serial No.
---- -------------------------------------------- ------------------ -----------
1 ASA 5506-X with SW, 8GE Data, 1GE Mgmt, AC ASA5506 JAD19
sfr Unknown N/A JAD194
Mod MAC Address Range Hw Version Fw Version Sw Version
---- --------------------------------- ------------ ------------ ---------------
1 00fe.c8c4.3111 to 00fe.c8c4.311a 1.1 1.1.8 9.9(2)
sfr 00fe.c8c4.3110 to 00fe.c8c4.3110 N/A N/A
Mod SSM Application Name Status SSM Application Version
---- ------------------------------ ---------------- --------------------------
Mod Status Data Plane Status Compatibility
---- ------------------ --------------------- -------------
1 Up Sys Not Applicable
sfr Unresponsive Not Applicable
When I run the "debug cplane " command, I see some errors mentioned below:
cp_connect: Connecting to card 1, socket 2, port 7000
cp_connect: Error - cp_connect() returned -1
cp_check_connection: handle -1, conflicts with connection 1 (-1)
cp_check_connection: handle -1, conflicts with connection 2 (-1)
cp_check_connection: handle -1, conflicts with connection 3 (-1)
cp_update_connection: Error updating connection_id 0
Is this a hardware issue?
The firewall no longer serve more?
