cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


795
Views
0
Helpful
5
Replies
Beginner

FMC-FTD Initialization

Hello all,

 

I'm using Virtual FTD and FMC. FTD registers with FMC but after sometime it's showing error in FTD Status, connectivity between FMC and FTD is ok. 

When I check from FTD cli by this command Show manager,

Show manager

syntax error: Illegal parameter

after again add manger in FTD Cli successfully added in FMC but when I check in 

device> device management> 
there's showing error.

5 REPLIES 5
VIP Rising star

Re: FMC-FTD Initialization

Can you share the error message on the FMC ?

Highlighted
Beginner

Re: FMC-FTD Initialization

I attached snapshot, please have a look.

VIP Rising star

Re: FMC-FTD Initialization

Maybe I am missing something, but in the snapshot I only see that the FTD has an error.

I do not see the message.

Message should be visible if you click on the red "!" top right.

Beginner

Re: FMC-FTD Initialization

please check, Screenshot_1.pngScreenshot_2.png

VIP Rising star

Re: FMC-FTD Initialization

Sorry for the late reply.

It seems the errors are caused by:

- time synchronization issues between FTD and FMC

- no traffic seen on some FTD interfaces, if the FTD is not actively used the error could be ignored

For time synchronization issues please check the following guide:

https://www.cisco.com/c/en/us/support/docs/security/firesight-management-center/118626-technote-firesight-00.html