FMC-FTD Initialization

[Jawad Ahmad]

Hello all,

I'm using Virtual FTD and FMC. FTD registers with FMC but after sometime it's showing error in FTD Status, connectivity between FMC and FTD is ok. 

When I check from FTD cli by this command Show manager,

Show manager

syntax error: Illegal parameter

after again add manger in FTD Cli successfully added in FMC but when I check in 

device> device management> 
there's showing error.

[Bogdan Nita]

Can you share the error message on the FMC ?

[Jawad Ahmad]

I attached snapshot, please have a look.

[Bogdan Nita]

Maybe I am missing something, but in the snapshot I only see that the FTD has an error.

I do not see the message.

Message should be visible if you click on the red "!" top right.

[Jawad Ahmad]

please check, 

[Bogdan Nita]

Sorry for the late reply.

It seems the errors are caused by:

- time synchronization issues between FTD and FMC

- no traffic seen on some FTD interfaces, if the FTD is not actively used the error could be ignored

For time synchronization issues please check the following guide:

https://www.cisco.com/c/en/us/support/docs/security/firesight-management-center/118626-technote-firesight-00.html

[opsy]

Hi team,

when i integration FMCv to Firepower2130 i got Syntax error: Illegal parameter 

[Marvin Rhoads]

@opsy you're replying to a 5 year old thread with a new issue.

Please start a new thread and include more details of what you are doing when encountering the error you mention.