I'm using Virtual FTD and FMC. FTD registers with FMC but after sometime it's showing error in FTD Status, connectivity between FMC and FTD is ok.
When I check from FTD cli by this command Show manager,
syntax error: Illegal parameter
after again add manger in FTD Cli successfully added in FMC but when I check in
device> device management>
there's showing error.
Maybe I am missing something, but in the snapshot I only see that the FTD has an error.
I do not see the message.
Message should be visible if you click on the red "!" top right.
Sorry for the late reply.
It seems the errors are caused by:
- time synchronization issues between FTD and FMC
- no traffic seen on some FTD interfaces, if the FTD is not actively used the error could be ignored
For time synchronization issues please check the following guide: