cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


855
Views
5
Helpful
5
Replies
Beginner

FMC not showing events

Hi Experts 

I've deployed 2 x ASA 5525x in HA. both devices have added in FMC. i can see that traffic is passing through the SFR module by using sh service policy command. but  vFMC is not showing any event on dash board.

- i've created a basic policy on FMC and pushed it toward firewalls.

- logs are enable in policy

- i am using vFMC 6.2.1/ SFR 6.2.0/ IOS 9.6.3 image 

Regards

 

5 REPLIES 5
Hall of Fame Guru

Can you share a screen shot

Can you share a screen shot of your Access Control Policy with logging enabled?

Highlighted

Make sure to follow below

Make sure to follow below path :

on the main page >> Analysis >> Connections >> Events 

Ensure Firewall is having traffic going through it, show conn would help 

Beginner

Re: FMC not showing events

 

 

Please enable logging in access control policy , i test it on FMCv 6.2.3.

 

Beginner

Re: FMC not showing events

You may also check if Time is sync/same in both FTD and FMC. 

Once common problem in eventing is, FTD sends event with different time stamp and FMC has different time, resulting no even shown up in FMC on expected time window.   

Beginner

Re: FMC not showing events

You may also check if Time is sync/same in both FTD and FMC. 

Once common problem in eventing is, FTD sends event with different time stamp and FMC has different time, resulting no even shown up in FMC on expected time window.