07-28-2013 11:50 PM - edited 03-11-2019 07:18 PM
Hi All
Problem again. Hope you all can help to solve.
I have internal server 10.200.13.1 for RDP access. But base on below config not are work.
Also if bypass this firewall can work.
: Saved
:
ASA Version 8.2(5)
!
hostname mkofficefw01
enable password XwzHd4VCVqrxvrzG encrypted
passwd 2KFQnbNIdI.2KYOU encrypted
names
!
interface Ethernet0/0
nameif HGC_BB
security-level 0
ip address 10.10.10.1 255.255.255.0
!
interface Ethernet0/1
description MK_Office_206
nameif MK_206
security-level 100
ip address 10.206.0.253 255.255.254.0
!
interface Ethernet0/2
description MK_Office_207
nameif MK_207
security-level 100
ip address 10.207.0.253 255.255.255.0
!
interface Ethernet0/3
no nameif
no security-level
no ip address
!
interface Management0/0
nameif management
security-level 100
ip address 172.32.1.1 255.255.255.0
management-only
!
ftp mode passive
same-security-traffic permit inter-interface
same-security-traffic permit intra-interface
access-list mk206_inside extended permit ip any any
access-list mk207_inside extended permit ip any any
access-list HGC_outside extended permit ip any any
access-list inside_nat_206_outbound extended permit ip any 10.206.0.0 255.255.254.0
access-list inside_nat_206_outbound extended permit ip 10.206.0.0 255.255.254.0 10.207.0.0 255.255.255.0
access-list inside_nat_206_outbound extended permit ip 10.206.0.0 255.255.254.0 10.201.0.0 255.255.0.0
access-list inside_nat_206_outbound extended permit ip 10.206.0.0 255.255.254.0 10.202.0.0 255.255.0.0
access-list inside_nat_206_outbound extended permit ip 10.206.0.0 255.255.254.0 10.204.0.0 255.255.0.0
access-list inside_nat_206_outbound extended permit ip 10.206.0.0 255.255.254.0 10.205.0.0 255.255.0.0
access-list inside_nat_206_outbound extended permit ip 10.206.0.0 255.255.254.0 10.210.0.0 255.255.0.0
access-list inside_nat_206_outbound extended permit ip 10.206.0.0 255.255.254.0 10.200.13.0 255.255.255.0
access-list inside_nat_207_outbound extended permit ip any 10.207.0.0 255.255.255.0
access-list inside_nat_207_outbound extended permit ip 10.207.0.0 255.255.255.0 10.200.0.0 255.255.0.0
access-list inside_nat_207_outbound extended permit ip 10.207.0.0 255.255.255.0 10.201.0.0 255.255.0.0
access-list inside_nat_207_outbound extended permit ip 10.207.0.0 255.255.255.0 10.202.0.0 255.255.0.0
access-list inside_nat_207_outbound extended permit ip 10.207.0.0 255.255.255.0 10.204.0.0 255.255.0.0
access-list inside_nat_207_outbound extended permit ip 10.207.0.0 255.255.255.0 10.205.0.0 255.255.0.0
access-list inside_nat_207_outbound extended permit ip 10.207.0.0 255.255.255.0 10.210.0.0 255.255.0.0
access-list inside_nat_207_outbound extended permit ip 10.207.0.0 255.255.255.0 10.206.0.0 255.255.254.0
pager lines 24
logging asdm informational
mtu HGC_BB 1500
mtu MK_206 1500
mtu MK_207 1500
mtu management 1500
icmp unreachable rate-limit 1 burst-size 1
icmp permit any HGC_BB
icmp permit any MK_206
icmp permit any MK_207
no asdm history enable
arp timeout 14400
global (HGC_BB) 1 interface
nat (MK_206) 0 access-list inside_nat_206_outbound
nat (MK_206) 1 10.206.0.0 255.255.252.0
nat (MK_206) 10 0.0.0.0 0.0.0.0
nat (MK_207) 0 access-list inside_nat_207_outbound
nat (MK_207) 1 10.207.0.0 255.255.255.0
nat (MK_207) 10 0.0.0.0 0.0.0.0
access-group HGC_outside in interface HGC_BB
access-group mk206_inside in interface MK_206
access-group mk207_inside in interface MK_207
route HGC_BB 0.0.0.0 0.0.0.0 10.10.10.2 1
route MK_206 10.200.0.0 255.255.0.0 10.206.0.254 1
route MK_206 10.201.0.0 255.255.0.0 10.206.0.254 1
route MK_206 10.202.0.0 255.255.0.0 10.206.0.254 1
route MK_206 10.204.0.0 255.255.0.0 10.206.0.254 1
route MK_206 10.205.0.0 255.255.0.0 10.206.0.254 1
route MK_206 10.210.0.0 255.255.0.0 10.206.0.254 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
timeout floating-conn 0:00:00
dynamic-access-policy-record DfltAccessPolicy
aaa authentication ssh console LOCAL
aaa authentication telnet console LOCAL
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
crypto ipsec security-association lifetime seconds 28800
crypto ipsec security-association lifetime kilobytes 4608000
crypto ca trustpoint _SmartCallHome_ServerCA
crl configure
telnet 10.0.0.0 255.0.0.0 management
telnet timeout 5
ssh 0.0.0.0 0.0.0.0 HGC_BB
ssh 10.0.0.0 255.0.0.0 management
ssh timeout 5
console timeout 0
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
username maxline password AxVGTgY4NjA2d3H8 encrypted privilege 15
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum client auto
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
inspect ip-options
inspect icmp
inspect icmp error
!
service-policy global_policy global
prompt hostname context
call-home reporting anonymous
Cryptochecksum:c8df6eda8684cac25cc5a0e927f9b39a
: end
Thank for your help !!!
Jacky
07-29-2013 12:12 AM
From which IP are you trying to access it?
Also what's the IP address you are putting into the RDP session? The real IP address for the server?
For Networking Posts check my blog at http://www.laguiadelnetworking.com/category/english/
Cheers,
Julio Carvajal Segura
07-29-2013 12:38 AM
sorry for my missing
is from mk_206(inside) to 10.200.13.1(inside)
Thank
Jacky
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: