07-14-2018 12:08 PM
Hi all,
I am kinda new to Cisco ASA... and i have just recieved an alert from the monitoring team saying that there's an alert reading "High Transmit Percent Utilization>80% - on Adaptive Security Appliance 'outside' interface · Outside . So can someone help me to how to go about doing this.. like what i should check... what commands to execute on ASA.... and how to verify if the alert has been resolved...
07-15-2018 03:29 PM
Hi abhijith891 , you could do from CLI (as well ASDM): show traffic, show interface outside and show perfmon for check what traffic it's generating alarms.
Also, you could check if you need block some traffic that you don't need. Sometimes some users don't' care about bandwidth...
And finally, the worst, you should check if your device it is the correct one for your environment.
The following links should help you with troubleshooting.
Troubleshooting:
CLI:
DataSheet Throughput
Regards.-
07-17-2018 01:41 PM
thanks for your suggestions... will definitely look into these...
07-17-2018 01:40 PM
thanks for your suggestions... will definitely look into these...
07-17-2018 07:17 PM
I hope you find it useful for your problem.
Regards.-
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide