cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


491
Views
0
Helpful
1
Replies
Highlighted
Beginner

Inter Vlan Multicast in FWSM.


Hi,

I am trying to make the Multicast working between two vlans defined in FWSM..

Hosts are running mysql cluster and Multicast is used to send master/slave status

information to the IP 228.10.10.10 on port 45566.


The vlan is  defined in FWSM and the host are connected via the core-switch(6513).

(hosts-->core-sws--->fwsm).. FWSM is running code 3.1(4).

I have enabled <multicast-routing> in FWSM. Just wondering if this is enough

to make it working ?

Any advice is higly appreciated.

Thanks in Advance.
kris

Everyone's tags (2)
1 REPLY 1
Hall of Fame Guru

Re: Inter Vlan Multicast in FWSM.

krishnadas.R wrote:


Hi,

I am trying to make the Multicast working between two vlans defined in FWSM..

Hosts are running mysql cluster and Multicast is used to send master/slave status

information to the IP 228.10.10.10 on port 45566.


The vlan is  defined in FWSM and the host are connected via the core-switch(6513).

(hosts-->core-sws--->fwsm).. FWSM is running code 3.1(4).

I have enabled in FWSM. Just wondering if this is enough

to make it working ?

Any advice is higly appreciated.

Thanks in Advance.
kris

Kris

Enabling multicast routing will enable pim on the FWSM interfaces so need to explicitly configure PIM. But you will need to configure an RP (Rendevous Point) for each multicast group. See attached for details -

FWSM RP

Jon

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here