05-13-2016 12:20 PM - edited 03-12-2019 12:45 AM
Anyone out there have the new Firepower 4100 NGFW. If so, in the firepower chassis manager are you using LDAP/Radius for authentication? I have LDAP/Radius working, but I only have read-only access after i connect to the chassis manager. Any help you can provide will be greatly appreciated.
05-16-2016 12:41 AM
Hello Bret,
Are you referring the follow link :-
http://www.cisco.com/c/en/us/support/docs/security/firesight-management-center/118738-configure-firesight-00.html
Could you please verify the settings once again and check if you have missed something.
Rate if this answer helps you.
Regards
jetsy
05-16-2016 05:09 AM
Jetsy,
This is for FireSight, where I am using the FirePower 4120. The interface for the 4120 Chassis Manager lacks the interface details noted in the FireSight document.
05-27-2016 04:39 AM
After opening a case I found that when configuring names on the FPR4120 for LDAP and SNMP you must use the FQDN. After adding the FQDN both LDAP and SNMP started working.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: