LDAP/Radius authentication on Firepower 4100 NGFW

[bret]

Anyone out there have the new Firepower 4100 NGFW. If so, in the firepower chassis manager are you using LDAP/Radius for authentication? I have LDAP/Radius working, but I only have read-only access after i connect to the chassis manager. Any help you can provide will be greatly appreciated.

[Jetsy Mathew]

Hello Bret,

Are you referring the follow link :-

http://www.cisco.com/c/en/us/support/docs/security/firesight-management-center/118738-configure-firesight-00.html

Could you please verify the settings once again and check if you have missed something.

Rate if this answer helps you.

Regards

jetsy

[bret]

Jetsy,

This is for FireSight, where I am using the FirePower 4120. The interface for the 4120 Chassis Manager lacks the interface details noted in the FireSight document.

[bret]

After opening a case I found that when configuring names on the FPR4120 for LDAP and SNMP you must use the FQDN. After adding the FQDN both LDAP and SNMP started working.