I'm currently establishing an IPSec VPN between a 2900 router and an ASA 5525. The purpose of this is to be able to get management access to a couple nodes at the remote site which is where the ASA is. The conflict is that I've learned that I can't access the management port of the same firewall where the VPN is terminated. Any suggestions? Trying to get this wrapped up by tomorrow.
Have you defined the command "management-access <interface>"?
Access ASDM/SSH Across a VPN Tunnel
"In order to access ASDM via the inside interface of ASA-2 from the ASA-1 inside network, you must use the command that is described here. This command can only be used for one interface. On ASA-2, configure management-access with the management-access inside command:"
You will obviously need to ensure you define the networks that can http to the ASA with the command "http network mask interface".
Looks like that command is in there. I will be changing routes to finish the configuration tomorrow. I was told by my senior engineer I may run into this problem so we will just see. Thanks for the feedback, I'll message back if it happens.