cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


164
Views
0
Helpful
2
Replies
Beginner

Management access for ASDM over IPSec

I'm currently establishing an IPSec VPN between a 2900 router and an ASA 5525.  The purpose of this is to be able to get management access to a couple nodes at the remote site which is where the ASA is.  The conflict is that I've learned that I can't access the management port of the same firewall where the VPN is terminated.  Any suggestions?  Trying to get this wrapped up by tomorrow.  

Everyone's tags (3)
2 REPLIES 2
RJI Advisor
Advisor

Re: Management access for ASDM over IPSec

Hi,

Have you defined the command "management-access <interface>"?

 

Reference here.

 

Access ASDM/SSH Across a VPN Tunnel

"In order to access ASDM via the inside interface of ASA-2 from the ASA-1 inside network, you must use the command that is described here. This command can only be used for one interface. On ASA-2, configure management-access with the management-access inside command:"

 

You will obviously need to ensure you define the networks that can http to the ASA with the command "http network mask interface".

 

HTH

Highlighted
Beginner

Re: Management access for ASDM over IPSec

Looks like that command is in there.  I will be changing routes to finish the configuration tomorrow.  I was told by my senior engineer I may run into this problem so we will just see.  Thanks for the feedback, I'll message back if it happens.

 

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here