cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
902
Views
5
Helpful
3
Replies

Multiple access-group in ASA Cisco Adaptive Security Appliance Software Version 9.1(5)16

tech_gubby
Level 1
Level 1

Hi Folks, 

I have been trying to configure multiple access-group in same interface in asa Version 9.1(5)16. But, i am able to configure only on access-group per interface. 

Can you please clarify me that, how many access-group can be configured per interface? and also please post the basics or facts about access-group in asa.

Quick help is much appreciated, Thank you all.. 

2 Accepted Solutions

Accepted Solutions

Hi,
You can only apply an ACL in each direction (inbound and outbound) on an interface. E.g.

access-group OUTSIDE_IN in interface OUTSIDE
access-group OUTSIDE_OUT out interface OUTSIDE

View solution in original post

Only 1 ACL can be configured per direction per interface. Normally you'd only apply the ACL in the inbound direction.

View solution in original post

3 Replies 3

Hi,
You can only apply an ACL in each direction (inbound and outbound) on an interface. E.g.

access-group OUTSIDE_IN in interface OUTSIDE
access-group OUTSIDE_OUT out interface OUTSIDE

Thank you for the prompt response. Could i take this - We can configure
only one access group can be configured per interface?

Only 1 ACL can be configured per direction per interface. Normally you'd only apply the ACL in the inbound direction.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: