No Traffic on FMC.

[Ninad Thakare]

I have installed FMC and registered 2 SFR module successful. 

I have also configured ASA to send traffic to SFR for traffic analysis but still I am not able to see any traffic on FMC being analyzed.

Below is the ASA config :

ASA/act# show service-policy sfr

Global policy:
Service-policy: global_policy
Class-map: global-class-sfr
SFR: card status Up, mode fail-open
packet input 3769932114, packet output 3770123526, drop 96788, reset-drop 0
ASA/act#

[hashimwajid1]

hi

i had the same issue, it solved once i enabled NTP  time synchronization  of  FTD devices via FMC. 

[Ninad Thakare]

Hi,

Yes, thought so but with NTP or manual setup still no success. I am not getting any data on dashboard.

[Marvin Rhoads]

By default connections are not logged.

Have you configured any access control policies with the "log" option turned on and/or specified the default intrusion policy to log connections?

[Ninad Thakare]

Hi Marvin,

I have set Intrusion Policy to "Balanced security and connectivity" and logging with "Log at end connection" for Allow traffic and "log at beginning of connection".

[Marvin Rhoads]

Can you share a screen shot of your access control policy page?