07-16-2015 06:40 PM - edited 03-11-2019 11:16 PM
Hi, all
Has anyone used the PIX 515 with PIX Security Appliance Software Version 7.2(1)?
It seems not to accept the command ip address for ethernet interface when I am in the config-int mode.
After that, I go into the monitor mode and upgrade the IOS. But it still can't assign ip address in the config-int mode.
Does anyone encounter the same problem? Thanks.
Solved! Go to Solution.
07-17-2015 12:03 AM
Your ASA seems to be in multiple config mode. There the interfaces are configured differently. Try to switch back with the "mode" command.
07-17-2015 12:03 AM
Your ASA seems to be in multiple config mode. There the interfaces are configured differently. Try to switch back with the "mode" command.
09-16-2015 01:55 AM
Thanks for Karsten, I think the PIX 515's software version is too old.
Anyway, when I change the mode form multiple to single, it work.
07-18-2015 05:26 AM
Please attach configuration
Regards,
Puneesh
Please rate helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: