cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


284
Views
0
Helpful
4
Replies
Highlighted

Port natting when no nat-control is set

Hello everybody,

is there any clue to NAT PORTS when no nat-control is active "Enable traffic through the firewall without address translation"?

thx in advanced alexx

Sorry I forgott, I uses a FWSM with 4.1(7). thx alexx

Everyone's tags (2)
4 REPLIES 4

Port natting when no nat-control is set

Hello Alexander,

Not sure if I understand your question...

Do you want to perform a port-forwarding rule while nat control is not enabled?

If that is the question there is no problem doing that, it's going to work whether you have nat-control on or not.

Any other question..Sure..Just remember to rate all of the helpful answers.

Julip

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC

Port natting when no nat-control is set

Are sure I have entred many port nattings but they still not working?? should I send the config...... thx alexx

Port natting when no nat-control is set

Hello Alexander,

Yes, post the NAT setup and packet-tracer outputs

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC

Port natting when no nat-control is set

Okay I will do it tomorrow, thx for help thx alexx

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here