05-26-2019 07:41 AM
we are upgrading an ASAv5 to an ASAv10 ....
can i just take the running config of the ASAv5 and paste it into the ASAv10?
Is there anything that might not copy over that i need to be concerned about or should this be straight-forward?
05-26-2019 07:52 AM
As long as both ASAs are on version 9.x you should be ok. nothing to worry.
05-26-2019 08:54 AM
05-26-2019 09:28 AM
vpn tunnel pre shared key can be seen by giving the command
more system:running-config
the above command will show you the pre-shared key configured for you vpn tunnels.
in regards to local username password you have to configure a new password your existing usernames
05-26-2019 11:08 AM
thanks for the reply , what is the cli commands to check the tunnel status ? once i migrate the config i will want to make sure the tunnels come back up .
05-26-2019 11:57 AM
there are few.
from cli
show vpn session
05-26-2019 03:42 PM
05-26-2019 11:38 PM
Hi,
use the below commands to see the VPN tunnel details
show vpn-sessiondb you can see the VPN session summary
show vpn-sessiondb l2l or show crypto isakmp sa you can see the site to site tunnel
show vpn-sessiondb anyconnect you can see the anyconnect clients connected
show vpn-sessiondb webvpn you can see the clients connected via webvpn
Hope This Helps
Abheesh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: