we are upgrading an ASAv5 to an ASAv10 ....
can i just take the running config of the ASAv5 and paste it into the ASAv10?
Is there anything that might not copy over that i need to be concerned about or should this be straight-forward?
As long as both ASAs are on version 9.x you should be ok. nothing to worry.
vpn tunnel pre shared key can be seen by giving the command
the above command will show you the pre-shared key configured for you vpn tunnels.
in regards to local username password you have to configure a new password your existing usernames
thanks for the reply , what is the cli commands to check the tunnel status ? once i migrate the config i will want to make sure the tunnels come back up .
use the below commands to see the VPN tunnel details
show vpn-sessiondb you can see the VPN session summary
show vpn-sessiondb l2l or show crypto isakmp sa you can see the site to site tunnel
show vpn-sessiondb anyconnect you can see the anyconnect clients connected
show vpn-sessiondb webvpn you can see the clients connected via webvpn
Hope This Helps