cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
394
Views
0
Helpful
2
Replies

remove split tunnel ACL list

Adam Coombs
Level 1
Level 1

Ok, I have change a VPN tunnel from Split tunnel to tunnel all traffic.

When I try to remove the ACL lines for the split tunnel I was getting deny.

ASA(config)# no access-list test_split_tunnel line  standard permi$

no access-list test_split_tunnel line 1 standard permit 192.168.1.0 255.255.0.0
                                        ^
ERROR: % Invalid input detected at '^' marker.

 

I want to remove all the lines like line 1 

This VPN connection is setup on Anyconnected, IOS 9.0, this VPN is working no issue I can find yet.  

Any help with this would be great

 

Thank you

1 Accepted Solution

Accepted Solutions

Vibhor Amrodia
Cisco Employee
Cisco Employee

Hi,

Try removing with "line 1":-

no access-list test_split_tunnel standard permit 192.168.1.0 255.255.0.0

It should work.

Thanks and Regards,

Vibhor Amrodia

View solution in original post

2 Replies 2

Vibhor Amrodia
Cisco Employee
Cisco Employee

Hi,

Try removing with "line 1":-

no access-list test_split_tunnel standard permit 192.168.1.0 255.255.0.0

It should work.

Thanks and Regards,

Vibhor Amrodia

Thank you very much Vibhor 

That work great, I am glad it was something so simple 

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: