RV345 SSL VPN access to site-to-site

[Obiben]

I have a RV345 set up with a site-to-site connection to an outside office. The site-to-site connects 192.168.20.0 to this satellite office, using IP group X. 

This router also has an SSL VPN setup. Clients who connect to this get into subnet 192.168.19.0. Is there any way for these people to reach X without adding 192.168.19.0 to both sides of the site-to-site configuration?

[Obiben]

I realize this is on the wrong board - should probably be posted in VPN section, but there is no delete function anywhere that I can find...

[nagrajk1969]

Hi

The below will work ONLY IF THE IPGROUP-X DOES NOT HAVE ANY SUBNETS starting with "192.168.x.0"

So in either side, just change the 192.168.20.0/24  subnet that you are mentioning in the S2S tunnel config to 192.168.0.0/16...it sshould support now both 192.168.19.0/24 and 192.168.20.0/24 subnets...