cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
577
Views
0
Helpful
0
Replies

SA520-K9 Wan State Down

zayar86
Level 1
Level 1

Hi Everyone,

 

I have two internet connections and I have a Cisco SA520 that is set up to do load balancing. 


The cisco router is connected to two upstream modems and both WAN ports are getting IPs automatically from the modems.

 

Everything was working fine until last Friday when it stopped forwarding traffic through the primary/dedicated WAN port. It says WAN State: Down. Firewalls, Other Firewalls

 

It is still getting an IP address but it looks like the dedicated WAN port is not forwarding any traffic. I can ping the IP of the interface but I can't ping the upstream modem.


I know the modem is working because I plugged a laptop directly into it and the internet works fine. It just doesn't work through the router. 

I was just wondering if you would be able to point me in the right direction on fixing this issue? 

Thanks a lot in advanced. :)

 

 

 

 

0 Replies 0
Review Cisco Networking products for a $25 gift card