cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1182
Views
0
Helpful
1
Replies

Static NAT at IPSEC tunnel endpoint on pix 6.3(5)

dave.jones
Level 1
Level 1

Good Morning all

I'm having an issue with an internal ipsec tunnel between two pix's. The tunnel is built between two outside interfaces but the packets are being dropped at the inside interface with a no traslation group error, despite having the correct statics in place.

Many thanks

DJ

1 Reply 1

r.waldron
Level 1
Level 1

DJ

DO you have the "sysopt connection permit-ipsec" command on both boxes ?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card