cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


77
Views
0
Helpful
7
Replies
Beginner

Switchport to ASA5510

I have just replaced a stack 3750 with a stack 3850.

After this i get around 6Mbit internet speed.

If i connect a pc directly to the isp equipment i get 87Mbit.

It was ok with the 3750 stack.

There are no vlan config on the ASA

What is the correct port config on the 3850 switch ?

The config right now is:

 

interface GigabitEthernet1/0/1

description Til ASA5510

switchport access vlan 201

switchport mode access

 

 

 

7 REPLIES 7
Beginner

Try to set speed 1000 and

Try to set speed 1000 and duplex full

Beginner

The ASA is not security+I

The ASA is not security+

I have tryed Speed 100 and full duplex

Beginner

What do you mean with "the

What do you mean with "the asa is not security+" ?

 

Beginner

ASA5510 need to bee sec+ to

ASA5510 need to bee sec+ to support giga on port 0 and 1

Beginner

Try to set speed 100 and

Try to set speed 100 and duplex full on port GigabitEthernet 1/0/1 on switch 3850

Beginner

New test.I connect a pc to a

New test.

I connect a pc to a port configuret as vlan 201 and get full speed.

It looks like the routing in the 3850 switches is extremely slow.

Highlighted
Beginner

I am disapointet :-(Cisco is

I am disapointet :-(

Cisco is delivering a layer3 switch wirh a firmware that cant route IP !!!!

Upgraded and everything is ok.

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here