Latest Tagged - Cisco Community

How many PVDM-12s can be added to the NM-HDV module on a Cisco 2600 router? - ( ‎06-17-2009 10:19 PM )

by on

0 Replies 1260 Views

0 Replies

1260 Views

Cannot break to ROMmon because the no service password-recovery command has been configured - ( ‎06-18-2009 04:04 PM )

by on Latest post on by

3 Replies 66697 Views

3 Replies

66697 Views

Voice card or module is not recognized in 1700, 2600, or 3600 series routers - ( ‎06-22-2009 03:43 PM )

by on

0 Replies 1852 Views

0 Replies

1852 Views

How to check if an IOS gateway router is compatible with Cisco CallManager in the MGCP mode - ( ‎06-22-2009 06:14 PM )

by on

0 Replies 2348 Views

0 Replies

2348 Views

How to choose and install software for the 801, 802, 803, 804, 805, 806, 826, 827, 828, 831, 836, SO... - ( ‎06-18-2009 03:50 PM )

by on

0 Replies 2307 Views

0 Replies

2307 Views

How to determine the amount of Flash and DRAM on a router - ( ‎06-22-2009 03:32 PM )

by on Latest post on by

6 Replies 180991 Views

6 Replies

180991 Views

A Cisco 2600 series router does not recognize the built-in Ethernet ports - ( ‎06-22-2009 04:05 PM )

by on

0 Replies 2663 Views

0 Replies

2663 Views

The user Cannot configure T.37 store-and-forward OnRamp on a Cisco 2611 router and callers from PSTN... - ( ‎06-22-2009 06:14 PM )

by on

0 Replies 1426 Views

0 Replies

1426 Views

LEDs are lit after powering on the router, but nothing appears on the console - ( ‎06-18-2009 03:51 PM )

by on

0 Replies 1462 Views

0 Replies

1462 Views

Modem and fax calls fail to train when connected through 2600 series gateways using an AIM-VOICE-30 ... - ( ‎06-22-2009 05:30 PM )

by on

0 Replies 860 Views

0 Replies

860 Views

Continuous boot loop due to insufficient memory - ( ‎06-22-2009 04:08 PM )

by on

0 Replies 3679 Views

0 Replies

3679 Views

A Cisco 2600, 3600 or 3700 series router goes into a boot loop with %ERR-1-GT64010: Fatal error, PCI... - ( ‎06-18-2009 03:52 PM )

by on

0 Replies 2606 Views

0 Replies

2606 Views

T.37 Fax Gateway store and forward fax receives only the first page - ( ‎06-22-2009 05:30 PM )

by on

0 Replies 1185 Views

0 Replies

1185 Views

A Cisco 2620 or 2621 series router does not recognize a 32 MB Flash SIMM due to an incompatible boot... - ( ‎06-22-2009 04:36 PM )

by on

0 Replies 8872 Views

0 Replies

8872 Views

Router reloads and boots in ROM Monitor (ROMmon # >) mode unexpectedly with a bad checksum error mes... - ( ‎06-18-2009 03:54 PM )

by on

0 Replies 2906 Views

0 Replies

2906 Views

ICA or CGP Priority TAG with CISCO NBAR - ( ‎10-25-2009 09:25 AM )

by on

0 Replies 1693 Views

0 Replies

1693 Views

Active calls get dropped after a consistent time period - ( ‎06-22-2009 05:31 PM )

by on

0 Replies 1291 Views

0 Replies

1291 Views

The tftpdnld command fails on a Cisco 2600 series router with the TFTP copy: operation terminated du... - ( ‎06-22-2009 04:37 PM )

by on

0 Replies 3855 Views

0 Replies

3855 Views

Watchdog timeouts on 2600 and 3700 series routers with an AIM module. Router locks up upon bootup - ( ‎06-22-2009 05:05 PM )

by on

0 Replies 1945 Views

0 Replies

1945 Views

NTP: Common issues and troubleshooting - ( ‎06-10-2009 02:53 AM )

by on Latest post on by

3 Replies 106827 Views

3 Replies

106827 Views

Clock slips continue after configuration of clocking on a 2600 series gateway, using an AIM-VOICE-30... - ( ‎06-22-2009 03:36 PM )

by on

0 Replies 5315 Views

0 Replies

5315 Views

An AIM is not recognized by a Cisco 2600/3600/3700 series router - ( ‎06-22-2009 04:37 PM )

by on

0 Replies 1685 Views

0 Replies

1685 Views

A Cisco 1700, 2600, 3600 or 3700 series router is unable to boot from a TFTP server from ROMmon mode... - ( ‎06-18-2009 03:59 PM )

by on Latest post on by

1 Replies 5707 Views

1 Replies

5707 Views

Fax transmissions are incomplete or corrupted due to digital clock slips on a Cisco 2600 or 3700 ser... - ( ‎06-22-2009 03:37 PM )

by on

0 Replies 789 Views

0 Replies

789 Views

A Cisco 2600 or 3600 series router boots to ROMmon mode when a modem is attached to the console port - ( ‎06-22-2009 04:39 PM )

by on

0 Replies 2583 Views

0 Replies

2583 Views

The calling name information is not passed from Cisco to Siemens IP phones when Siemens Hicom 300 is... - ( ‎06-22-2009 05:09 PM )

by on

0 Replies 1508 Views

0 Replies

1508 Views

How to upgrade the system Flash in the Cisco 2600 series routers - ( ‎06-22-2009 05:34 PM )

by on

0 Replies 6717 Views

0 Replies

6717 Views

Cisco 2600, 3600, and 3700 series routers reload continuously - ( ‎06-22-2009 04:39 PM )

by on

0 Replies 1499 Views

0 Replies

1499 Views

Router does not power and no LEDs are lit - ( ‎06-18-2009 04:01 PM )

by on Latest post on by

1 Replies 51298 Views

1 Replies

51298 Views

WIC-1B-U physical ISDN connectivity issues - ( ‎06-22-2009 05:34 PM )

by on

0 Replies 1767 Views

0 Replies

1767 Views

Garbage output is seen on the console port - ( ‎06-17-2009 10:15 PM )

by on

0 Replies 10716 Views

0 Replies

10716 Views

The tftpdnld ROMmon command recovery procedure fails due to invalid syntax or variables - ( ‎06-18-2009 04:02 PM )

by on Latest post on by

4 Replies 78169 Views

4 Replies

78169 Views

The squeeze command does not work on a Cisco 2600 or 3600 series router with Cisco IOS® Software ver... - ( ‎06-22-2009 03:40 PM )

by on

0 Replies 20287 Views

0 Replies

20287 Views

User experiences no audio or one-way audio on IP phones when calls are placed across 2691 or 3700 ga... - ( ‎06-22-2009 04:42 PM )

by on

0 Replies 3314 Views

0 Replies

3314 Views

CLI Help on the 2621XM Series router with Cisco IOS 12.2 states that the aaa authorization network c... - ( ‎06-22-2009 05:12 PM )

by on

0 Replies 1030 Views

0 Replies

1030 Views

The 2600, 3600 and 3700 series routers boot continuously after the Cisco IOS Software upgrade due to... - ( ‎06-22-2009 03:42 PM )

by on

0 Replies 2123 Views

0 Replies

2123 Views

Alarm LED lit on WIC-1DSU-T1 - ( ‎06-22-2009 06:05 PM )

by on

0 Replies 16324 Views

0 Replies

16324 Views

Reset a Ciso Router - ( ‎12-19-2011 04:22 PM )

by on Latest post on by

6 Replies 1454 Views

6 Replies

1454 Views

wic-1enet and wic-4esw - ( ‎11-20-2010 02:25 PM )

by on Latest post on by

3 Replies 1318 Views

3 Replies

1318 Views

Please help: Frame relay switch interface fluctuating - ( ‎04-19-2011 07:03 AM )

by on Latest post on by

2 Replies 1423 Views

2 Replies

1423 Views

"xmodem:: permission denied" when upgrading IOS through ROMMON - ( ‎02-02-2011 07:31 PM )

by on Latest post on by

1 Replies 2140 Views

1 Replies

2140 Views

SDM 2.5 and Windows 7, IE 9 issues? Required for CCNA Security :( - ( ‎11-02-2011 06:04 PM )

by on Latest post on by

9 Replies 11261 Views

9 Replies

11261 Views

Upgrading flash memory on a Cisco 2651XM? - ( ‎12-22-2011 12:41 AM )

by on Latest post on by

1 Replies 1124 Views

1 Replies

1124 Views

Is it possible to replace rommon on 2620 - ( ‎06-24-2012 03:05 PM )

by on Latest post on by

7 Replies 856 Views

7 Replies

856 Views

How to assign multiple IP in one or sub interface - ( ‎11-03-2010 05:29 AM )

by on Latest post on by

18 Replies 7932 Views

18 Replies

7932 Views

Can't connect to internet - Home Lab question (CCNA) - ( ‎12-19-2012 08:14 AM )

by on Latest post on by

3 Replies 2063 Views

3 Replies

2063 Views

Clock Settings on Multiple PTP T1's - ( ‎12-12-2013 03:51 PM )

by on Latest post on by

5 Replies 593 Views

5 Replies

593 Views

DOT1Q Trunk between 6500 with CatOS / IOS and 2621 - ( ‎10-26-2011 12:06 PM )

by on Latest post on by

1 Replies 701 Views

1 Replies

701 Views

Router not using all available bandwidth? - ( ‎08-09-2011 06:59 PM )

by on Latest post on by

9 Replies 2420 Views

9 Replies

2420 Views

Static NAT connection dropped. - ( ‎10-11-2013 08:07 AM )

by on Latest post on by

1 Replies 641 Views

1 Replies

641 Views