Latest Tagged - Cisco Community

Connectivity issues when the "ip routing" command is configured in Catalyst 3750 series switches - ( ‎06-18-2009 03:54 PM )

by on

0 Comments 690 Views

0 Comments

690 Views

Unable to access a Catalyst switch with the web-based device manager or web interface utility - ( ‎06-22-2009 06:06 PM )

by on

0 Comments 5970 Views

0 Comments

5970 Views

Log messages do not show the date and time, but instead show the length of time the router has bee... - ( ‎06-22-2009 05:12 PM )

by on

0 Comments 47879 Views

0 Comments

47879 Views

Cannot browse the Internet through the GRE tunnel, but able to ping and Telnet - ( ‎06-22-2009 04:36 PM )

by on

0 Comments 2389 Views

0 Comments

2389 Views

The "%C4K_HWPORTMAN-4-BLOCKEDTXQUEUE" error message on Cisco Catalyst 4500 series switches connected... - ( ‎06-22-2009 05:34 PM )

by on Latest post on by

2 Comments 21811 Views

2 Comments

21811 Views

The user cannot establish a connection across a trunk link due to misconfiguration - ( ‎06-22-2009 05:06 PM )

by on

0 Comments 902 Views

0 Comments

902 Views

When configuring QinQ Support, the encapsulation dot1q X second-dot1q any command breaks Layer 3 con... - ( ‎06-22-2009 06:07 PM )

by on

0 Comments 6546 Views

0 Comments

6546 Views

A Supervisor 720-based Catalyst 6500 that runs Cisco IOS Software experiences failover because the f... - ( ‎06-22-2009 06:16 PM )

by on

0 Comments 1193 Views

0 Comments

1193 Views

Switch port is in errdisable status due to a duplex mismatch - ( ‎06-18-2009 04:03 PM )

by on

0 Comments 6153 Views

0 Comments

6153 Views

An iBGP learned route is not advertised - ( ‎06-22-2009 04:40 PM )

by on

0 Comments 3006 Views

0 Comments

3006 Views

A Novell IPX workstation does not have the Novell Login Screen at bootup due to spanning tree delays - ( ‎06-22-2009 05:35 PM )

by on

0 Comments 864 Views

0 Comments

864 Views

Cannot Telnet to a router with NAT enabled. Clearing the NAT table only temporarily resolves the pro... - ( ‎06-22-2009 05:07 PM )

by on

0 Comments 1583 Views

0 Comments

1583 Views

The "%DOT1X_SWITCH-5-ERR_ADDING_ADDRESS:" error message appears in Cisco Catalyst 3550 or 3750 serie... - ( ‎06-22-2009 06:07 PM )

by on Latest post on by

2 Comments 7225 Views

2 Comments

7225 Views

The traceroute command fails rather than displays round-trip time or timing out, and an A appears in... - ( ‎06-22-2009 04:04 PM )

by on

0 Comments 2297 Views

0 Comments

2297 Views

Alignment error counter increments due to a misconfiguration or physical layer issue - ( ‎06-22-2009 05:12 PM )

by on

0 Comments 18572 Views

0 Comments

18572 Views

Catalyst 3500XL switches always connect at half duplex. When hardset to full duplex, the connection ... - ( ‎06-22-2009 04:41 PM )

by on

0 Comments 1316 Views

0 Comments

1316 Views

User cannot get a Gigabit Ethernet link up between a Cisco switch and a non-Cisco device due to auto... - ( ‎06-22-2009 03:40 PM )

by on

0 Comments 1215 Views

0 Comments

1215 Views

Giant frames are seen on the Catalyst 2900/3500 XL switch when connected to another switch - ( ‎06-22-2009 05:07 PM )

by on

0 Comments 1979 Views

0 Comments

1979 Views

The user is unable to ping the management IP of a Catalyst 2940 series switch, but data traffic work... - ( ‎06-22-2009 06:14 PM )

by on

0 Comments 1573 Views

0 Comments

1573 Views

When the mac-address is deleted on a Catalyst 3750 series switch, unicast packets flood - ( ‎06-22-2009 06:17 PM )

by on

0 Comments 782 Views

0 Comments

782 Views

Input queue drops and throttles on an interface - ( ‎06-18-2009 04:04 PM )

by on

0 Comments 27853 Views

0 Comments

27853 Views

TFTP transfer times out after 10 minutes due to the exec-timeout default setting - ( ‎06-17-2009 10:15 PM )

by on Latest post on by

1 Comments 14659 Views

1 Comments

14659 Views

BGP packets bring ISDN link up - ( ‎06-22-2009 03:41 PM )

by on

0 Comments 1307 Views

0 Comments

1307 Views

The "% WARNING: Interface TenGigabitEthernet [mod/port] is usable/operational in all or tengigabit u... - ( ‎06-22-2009 05:07 PM )

by on

0 Comments 7654 Views

0 Comments

7654 Views

Connectivity issues between subnets connected to the same Router - ( ‎06-22-2009 06:14 PM )

by on

0 Comments 6510 Views

0 Comments

6510 Views

How to connect to my 871W etc. - ( ‎09-10-2011 04:24 PM )

by on

0 Comments 903 Views

0 Comments

903 Views

Parity errors and packet drop issues in the Catalyst 6500 switch with 7600-SIP-400 line card and Sup... - ( ‎06-22-2009 05:28 PM )

by on

0 Comments 1313 Views

0 Comments

1313 Views

There is an OSPF connectivity issue after the VTP mode is changed to Transparent in Catalyst switche... - ( ‎06-22-2009 04:41 PM )

by on

0 Comments 1259 Views

0 Comments

1259 Views

User cannot access the Internet or internal network due to routing protocol misconfiguration or misb... - ( ‎06-22-2009 03:42 PM )

by on

0 Comments 1014 Views

0 Comments

1014 Views

Input errors appear after the Auto-MDIX feature is enabled on a WS-X6748-TX module in Catalyst 6500 ... - ( ‎06-22-2009 05:08 PM )

by on

0 Comments 5999 Views

0 Comments

5999 Views

Sm-X-T3/E3 cards installation and Troubleshooting. - ( ‎01-12-2014 08:25 PM )

by on

0 Comments 7000 Views

0 Comments

7000 Views

The user cannot Telnet or connect to some applications of an IP-based application server - ( ‎07-01-2009 12:59 AM )

by on

0 Comments 3241 Views

0 Comments

3241 Views

HSRP instability occurs on certain router platforms connected through LAN switches - ( ‎06-22-2009 03:33 PM )

by on

0 Comments 1464 Views

0 Comments

1464 Views

Certain counters rapidly increase in the show port command output on Catalyst switches that run CatO... - ( ‎06-17-2009 10:20 PM )

by on

0 Comments 12573 Views

0 Comments

12573 Views

Router does not respond to pings at 100 percent - ( ‎06-22-2009 03:42 PM )

by on

0 Comments 7208 Views

0 Comments

7208 Views

User cannot link between two switches due to an incorrect Ethernet cable - ( ‎06-22-2009 05:08 PM )

by on

0 Comments 1483 Views

0 Comments

1483 Views

The user is unable to successfully ping a destination - ( ‎07-01-2009 03:25 AM )

by on

0 Comments 1398 Views

0 Comments

1398 Views

How to protect Cisco Catalyst switches from unicast flooding - ( ‎06-22-2009 03:34 PM )

by on

0 Comments 1030 Views

0 Comments

1030 Views

Mejoras en el núcleo - ( ‎11-17-2011 08:05 PM )

by on

0 Comments 278 Views

0 Comments

278 Views

Interfaces are down and unable to establish the connection in Catalyst 6500 or 7600 Series Switches ... - ( ‎06-22-2009 05:38 PM )

by on

0 Comments 1068 Views

0 Comments

1068 Views

Port status is errdisable due to EtherChannel misconfiguration - ( ‎06-22-2009 05:10 PM )

by on

0 Comments 21773 Views

0 Comments

21773 Views

Unable to obtain an IP address from a DHCP server even when the "ip helper address" command is confi... - ( ‎07-01-2009 04:12 AM )

by on

0 Comments 17605 Views

0 Comments

17605 Views

Cannot access devices on a directly connected subnetwork - ( ‎06-22-2009 03:35 PM )

by on

0 Comments 880 Views

0 Comments

880 Views

Error - "%ETHCNTR-3-LOOP_BACK_DETECTED" Catalyst switch that runs Cisco IOS® Software - ( ‎06-22-2009 04:46 PM )

by on Latest post on by

3 Comments 55309 Views

3 Comments

55309 Views

VLANs disappear and connectivity is lost due to the addition of a new switch to the network. This ca... - ( ‎06-22-2009 05:38 PM )

by on

0 Comments 8590 Views

0 Comments

8590 Views

The "%SECURITY-1-PORTSHUTDOWN:" error message is received in Catalyst 4500 or 6500 series switches r... - ( ‎06-22-2009 05:10 PM )

by on

0 Comments 1430 Views

0 Comments

1430 Views

Performance issues when Layer 2 traffic is dropped due to a uRPF failure after a VLAN is shut down o... - ( ‎06-22-2009 04:09 PM )

by on

0 Comments 807 Views

0 Comments

807 Views

HSRP brings ISDN link up - ( ‎06-22-2009 03:37 PM )

by on

0 Comments 1644 Views

0 Comments

1644 Views

Static route is not redistributed - ( ‎06-22-2009 04:46 PM )

by on

0 Comments 14686 Views

0 Comments

14686 Views

Unable to ping through a Catalyst 3750 Metro switch with MPLS configured on the standard port - ( ‎06-22-2009 05:39 PM )

by on

0 Comments 1196 Views

0 Comments

1196 Views