02-27-2019 11:26 AM - edited 02-21-2020 11:03 AM
We were trying to determine if there is a solution to limit then number of MAC addresses learned on a port if 802.1x is deployed in multi-auth mode. I had previously read not to use 802.1x and port-security. I have also read that is not a supported solution.
Solved! Go to Solution.
02-27-2019 12:06 PM
to my knowledge cisco best practice is not to configure 1.x with port-security. unless they change this practice or i gone too old.
02-27-2019 11:43 AM
to this date there is no solution to combine the 802.1x with port security. and it still stand not combine the port-security and dot1x on same port. as port-security is at switch level and 1.x is ISE feature.
02-27-2019 12:04 PM
02-27-2019 12:06 PM
to my knowledge cisco best practice is not to configure 1.x with port-security. unless they change this practice or i gone too old.
02-27-2019 12:27 PM
02-27-2019 04:49 PM
I have read that it was not a best practice. I just wanted to make sure.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: