Are there any guides on using ISE 2.x for RADIUS device administration?

[Tim Baum]

Are there any guides on how to configure ISE 2.x to use RADIUS for device administration? Is there a way, or reason, to send RADIUS packets to the Device Admin Policy Sets?

Thanks

[Jason Kunst · Accepted solution]

don't think you can send radius to the device admin policy sets

Also there is no guide that I know of published by the ise team

check out this thread

https://communities.cisco.com/message/243303

copying SME kthiruve as well

[hslai]

ISE Device Admin Policy Sets are for T+ only. If using RADIUS, then use the regular policy sets, which are for RADIUS. Device admins depend largely on the NAD implementations so please refer to the specific NAD platform documentations.