cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
991
Views
0
Helpful
3
Replies

Cisco Anyconnect NAM

Hi,

 

We have a scenario where we want to install Cisco anyconnect NAM.

 

Cisco NAM has a dependency services:- Wired and WLAN AutoConfig.


If either of the services are not enabled the NAM wont work.

 

Now, as we have desktop only scenario we don't want to enable WLAN Autoconfig for security purpose.

doing that NAM service becomes unavailable and it doesnt start.

 

As anyone found a way for the same to make it work?

Please suggest a way for this if anything possible.

 

3 Replies 3

Surendra
Cisco Employee
Cisco Employee

It doesn't work.. I have tried that as well. I removed it and even the profile doesn't get updated during installation and even post doing manual change also..

If wlan auto config disabled it's a service unavailability and it doesn't work at all.

I think it's hard coded to but there has to be a way..

Have you tried asking under the Anyconnect forum? As this really doesn’t have much to do with ise
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: