Find the number of endpoints running Cisco NAC and AnyConnect

[dgaikwad]

Hello Experts,

This is a part of the upgrade process from Cisco NAC to AnyConnect.
This upgrade is going to be phased manner.
I was able to find a this attribute, PostureAgentVersion. But, was not able to use it in anyway in the Client Provisioning policies...
The question is that, is there any way in ISE that I can use to see the number of endpoints running Cisco NAC and AnyConnect?
Does ISE provide such a way?

[paul]

Couldn't you just setup an application check condition in audit mode to check for the NAC agent service?  Then run the posture condition reports to look for devices that still have it installed?