cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1281
Views
0
Helpful
2
Replies

ISE 2.X Posture Check Disk Encryption

Thomas Wall
Cisco Employee
Cisco Employee

Team,

Starting in 2.0, ISE supports posture checks for disk encryption for Windows and Mac clients. However you have to specify the vendor when you define the posture condition. Is there a plan to add the functionality for an administrator to create a posture condition which checks for "Any" Vendor or is this a limitation with OPSWAT directly? 

Thomas Wall

1 Accepted Solution

Accepted Solutions

Charlie Moreton
Cisco Employee
Cisco Employee

This might work for you (I am using ISE 2.2):

Create an Application Condition, Choose the Operating System, Check By Application.  Choose the Application State you want to check (Installed, Running, or Both), Provision by Category and choose Encryption.

AnyDiskEncryption.PNG

View solution in original post

2 Replies 2

Charlie Moreton
Cisco Employee
Cisco Employee

This might work for you (I am using ISE 2.2):

Create an Application Condition, Choose the Operating System, Check By Application.  Choose the Application State you want to check (Installed, Running, or Both), Provision by Category and choose Encryption.

AnyDiskEncryption.PNG

Thank you for the prompt response! I'll test this workaround out.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: