ISE in Standalone mode.

[Joe Montes]

Hi everyone,

We are redeploying an 3595 running ISE  and would like to utilise the additional interfaces on the appliance for separate functions as per below:

Gig 0 - management

Gig 2 - Radius

Gig 4 - Guest Portal

I know we can definitely define a separate interface for the guest portal, but can't see any documentation on definining a separate interface for RADIUS and whether this is supported on standalone mode.  There's a similar reference to this on a another thread but referencing a distributed deployment (https://community.cisco.com/t5/identity-services-engine-ise/ise-multiple-interfaces-for-management-tacacs-radius-guest/td-p/3458926).

Cheers,

[Surendra · Accepted solution]

You cannot define a separate interface as such for RADIUS on ISE but ISE will listen on all the interfaces for RADIUS requests. What you can do is point the RADIUS requests (configure the desired interface IP as the RADIUS server on the NADs) to the interface.

[Joe Montes · Accepted solution]

Thank you.