06-05-2017 04:05 AM
I have an ISE using two interfaces.
I am unable to ping out of the second interface (gig1). There are no packets showing Rx or Tx.
The working interface (gig0) shows a status of "Up, Running and Broadcast" but the second interface (gig1) only shows "Up and Broadcast".
Does anyone know what the "running" state means and how to get the second interface into a running state (if that's what required)?
Regards
John
Solved! Go to Solution.
06-05-2017 07:50 AM
Make sure it is not configured as a backup interface. Make sure it has an IP address and mask. All requests will follow static route table so expect only local requests to go out local interface without static routes (or default) configured.
06-05-2017 07:50 AM
Make sure it is not configured as a backup interface. Make sure it has an IP address and mask. All requests will follow static route table so expect only local requests to go out local interface without static routes (or default) configured.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: