cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
 
ISE 2.3 Patch 7 has been posted. This will be the last patch for the ISE 2.3 release!
Choose one of the topics below to view our ISE Resources to help you on your journey with ISE

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

285
Views
2
Helpful
2
Replies
Highlighted
Cisco Employee

NEAT and Native VLAN Setup

Hi Team, 

Good day!  
This would be a generic question regarding a NEAT setup in the customer's environment. So as per the customer's requirement, 
they would like to push a Native VLAN to the Trunk port on the Authenticator Switch. This is required as there is a Native VLAN 
mismatch between the Supplicant and Authenticator Switch, which doesn't let the traffic through.  From what I understood in trying 
to set it up, I couldn't find any relevant document/article which said a Native VLAN could be pushed from ISE, but however would 
like to confirm on the same.  Any inputs or advices on the same would be very helpful.  
Thank you! 
Regards 
Mohammed Nazeeh
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: NEAT and Native VLAN Setup

Hi Mohammed,

Try this:

NEAT with Interface Template

Cheers!

-Hari

2 REPLIES 2
Cisco Employee

Re: NEAT and Native VLAN Setup

Hi Mohammed,

Try this:

NEAT with Interface Template

Cheers!

-Hari

Cisco Employee

Re: NEAT and Native VLAN Setup

Hi Hari,

Thank you for the response.

It was a doc which I never came across. That really did help me out.

Regards

Nazeeh