cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
334
Views
0
Helpful
1
Replies

Polling Gaps

IanBeggs40385
Level 1
Level 1

Hey there Everyone. I am trying to find more information on how the polling is done through Hardware VPN set up. Is it done through a trace Route or a ping? Currently my company states that a polling gap of more than 2 minutes means that there was simply a lack of internet connection to the hardware VPN. Not my definition. LOL. I will post an example of what i am talking about. Any insight? Keep in mind that when I run this through UC tools , in many cases, I show no packet loss, latency, Jitter or drop in MOS during the times the polling gaps exceed 3 minutes.  Thanks 

 

1 Accepted Solution

Accepted Solutions

Jason Kunst
Cisco Employee
Cisco Employee
This is the forum for ISE please move it to appropriate hardware forum, not sure where perhaps for ASA?

View solution in original post

1 Reply 1

Jason Kunst
Cisco Employee
Cisco Employee
This is the forum for ISE please move it to appropriate hardware forum, not sure where perhaps for ASA?
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: