cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
532
Views
0
Helpful
1
Replies

Problem with Data Access Permission for Endpoints

Jonathan Grim
Cisco Employee
Cisco Employee

Looking for help with a Data Access Permission issue.

 

The admin should only be able to add or delete an endpoint to a pre-defined endpoint identity group. 

  • Good - When the admin logs into ISE, they only see the endpoints from the specified endpoint group. 
  • Problem - When the admin creates a new endpoint and tries to assign the static identity group, there aren't any groups to pick from.

 

Screen Shot 2019-05-21 at 5.46.01 PM.png

 

Screen Shot 2019-05-21 at 5.51.02 PM.png

Screen Shot 2019-05-21 at 5.48.23 PM.pngScreen Shot 2019-05-21 at 5.48.06 PM.png

1 Reply 1

Hi @Jonathan Grim 

 

Please check this thread Community Thread about Identity Management Access

 

HTH

Regards,
Sathiyanarayanan Ravindran

Please rate the post and accept as solution, if my response satisfied your question:)
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: