10-28-2018 06:36 AM
Hi,
I want to bonding Eth0 and Eth1 into Bond0 interface in Cisco ISE 2.4. But I confuse what I should configure in switch which connected to Cisco ISE.
The Cisco ISE is SNS-3595-K9.
Does the switch need to configure etherchannel? Or just normal switchport access for both Cisco ISE interface?
Thank you
Arie
Solved! Go to Solution.
10-28-2018 10:03 AM
just leave in switch port mode.
10-28-2018 08:52 AM
When we bond 2 interfaces on ISE then one Ethernet is in standby mode and one is in active. We do NIC-bonding for redundancy.
We can directly connect the Ethernet ports to the switch port.
10-28-2018 09:52 AM
Hi,
In the switch, what do I need to configure? Do I need configure port channel on the switch port? Or just leave it as switchport mode access?
10-28-2018 10:03 AM
just leave in switch port mode.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide